Blu Cigs

Unboxing

The first step is to open up the box. Inside your blu Starter Kit you will find

• 1x blu pack, which holds 5 cartridges & charges your batteries on the go!
• 1x blu battery
• 1x blu spare battery
• 1x atomizer
• 1x spare atomizer
• 1x wall charger
• 1x USB charger
• 1x carton of cartridges in the strength of your choice.

Set Up/Initial Use

For optimal performance, it is recommended that you fully charge the batteries and blu pack before using blu.

You will notice that one of the batteries and the atomizer are pre-assembled along with an empty cartridge. Simply replace the empty cartridge with a full one by placing it firmly onto the atomizer. To make sure the cartridge is secure, twist it slightly.

There is no on or off switch. As you press blu to your lips and inhale, the blue LED light at the tip glows like a real cigarette to let you know it's working.

Charging Pack

Both the pack and the batteries can be charged using a standard wall outlet, or computer with USB port.

To charge the pack using a wall outlet, simply plug the wall charger into the outlet and connect the opposite end to the bottom of the pack. When the blue light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.

To charge the pack using the enclosed USB charger, unplug the USB cord from the wall charger and connect one end of the cable to the pack and the other to the USB port. When the blue light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.

blu Pack as Battery Charger

Second from the right, inside each pack, is a battery receptor.

Screw the battery into the receptor until it is secure. The blue LED light on your battery will flash and the blue light on the side of the pack will light up. When the light is on it means the battery is charging. When the light turns off, the battery is completely charged.

Simply unscrew the battery from the receptor and leave it in the same slot in the pack. If the battery is left screwed into the receptor after charging it will drain the charge from the battery.

Replacing Batteries

Each battery should provide approximately two cartridges worth of full-flavored enjoyment between charges while your blu pack will refresh your batteries up to 6 times before requiring a recharge. When the battery is depleted, the blue LED at the end of the battery will blink 30 times intermittently. To replace the empty battery, secure the cartridge in one hand and unscrew the battery from the atomizer. Grab the fresh battery from your blu pack and reattach it to the atomizer. When you're finished, recharge the empty battery by screwing it back into the receptor. Remember to unscrew a newly charged battery from the receptor when the light goes out. Note: During use, the LED light will flash 10 times to warn you that you are overusing your blu and you should take a break. This does not affect performance and does not mean you should recharge.

Replacing Cartridge

On average, each individual cartridge supplies enough nicotine and premium flavoring to accommodate approximately 100 puffs. When the cartridge no longer produces vapor, you'll know it's time for a replacement.

To replace the cartridge, hold the battery with one hand and pull off the empty one.

Check the atomizer for any foil residue and gently brush it aside using your fingers.

Firmly apply a full cartridge to the atomizer, twist it slightly to make sure it is secure